 |
The handling
fixtures are bolted to the top half of your die set, utilizing existing tapped holes. The
fixture can be bolted to top, front, back or sides of your die set.
Although one set of fixtures usually accommodates the range of most die sets, ITNAC
designs and engineers the fixtures to match your specific handling needs. |
Fixtures are easily bolted to the top
half of the die set for separation,
rotation and re-assembly operations. |
Once the center of gravity is is found, the top half can easily be separated from
the bottom half of the die set by using your crane system. Now that the die is separated,
it can be easily rotated with the FLIP-RITE.TM |
|
 |
Many die
shops are using the FLIP-RITETM for handling die sets.
The benefit is that with your crane and the FLIP-RITETM
you can manipulate your die half in all three axis, thus enabling your operator to lift,
level and rotate while equalizing the pressure on your die posts, for easy separation. The
secret to separating any die set is to locate the center of gravity of the top half of the
die. The wheeled trolley leveler unit finds the center of gravity from end to end and the
rotation shaft from front to back with the FLIP-RITE.TM |
After the top half of
the die is repaired,
it can be easily re-assembled by leveling
the die and lowering it with the crane system. |
|
This procedure can usually be completed in a fraction of the time it would normally take.
Once the center of gravity is determined, the operator can easily separate the die set by
lifting the FLIP-RITE with his crane system. Once the die is separated it can be rotated
for maintenance and repair work. Re-assembling is just as easy. You can start and stop the
rotation of your die set at any time. The complete die set can be rotated if required. The
FLIP-RITETM is controlled from a hand held pendant, just
like your crane.
Engineered to your needs - from 500 lbs. to 100 tons, the FLIP-RITETM
can be used anywhere in your facility that is serviced with a crane.
|
